濟南防水http://www.stxcw.cn/分析根據地基加固要求，施工過程中應做好詳細施工記錄，并進行地面變形測量監控，施工結束后，請提供有關施工報告給設計單位，壓密注漿施工需加強施工質量管理。

1、濟南防水談到壓密注漿原理是通過注漿管將漿液均勻的注入地層中，漿液以填充、滲透和擠密等方式，趕走土顆粒間或巖土裂隙中的水份和空氣后占據其位置，經人工控制一定時間后，漿液將原來松散的土?；蛄严赌z結成一個整體。因考慮到現場的實際情況，注漿量每米孔深注漿水泥用量暫定80kg，水泥漿采用P.O32.5普通硅酸鹽水泥配置，水泥漿的水灰比0.5。
Jinan waterproof Speaking after compaction grouting works by injecting grouting pipe uniform slurry formation, slurry to fill, penetration and compaction, etc., off the rock fissures or between soil particles in the water and air to take its position, manual control after a certain time, the original slurry loose soil particles or cracks cemented as a whole. By taking into account the actual situation at the scene, per meter deep hole grouting cement grouting provisional 80kg, grout using ordinary portland cement P.O32.5 configuration, grout cement ratio 0.5.

2、濟南防水分析單管靜壓注漿的壓力宜采用低壓滲透，注漿速度與注漿壓力取值應以地表面冒漿為控制原則。
Jinan waterproof analyze single tube hydrostatic pressure grouting should adopt the low pressure penetration, speed and grouting grouting pressure value should take slurry to the surface control principle.

3、濟南防水http://www.stxcw.cn/分析介紹注漿過程中有地下水冒出地面時，需在周?chē)O置排水溝，安排人員用潛水泵排出施工場地；待漿液冒出后，須停止一小段時間后再注漿。
When analyzing Jinan waterproof grouting process describes groundwater out of the ground, set around drains, arrange the construction site with submersible pump discharge; After the slurry out, shall cease for a short time after grouting.